Faculty of Mechanical Engineering, University of Zenica , Zenica , Bosnia and Herzegovina
Faculty of Mechanical Engineering, University of Zenica , Zenica , Bosnia and Herzegovina
University of Sarajevo , Sarajevo , Bosnia and Herzegovina
Faculty of Mechanical Engineering, University of Zenica , Zenica , Bosnia and Herzegovina
The general solution of the plane problem in plastic region was given in the paper. This solution is limited to polar coordinates and the nonhardening material. In the paper are given same individual solutions of problems in the plastics region on the basis of the general solution. In this paper, on the basis of results of two papers earlier mentioned, the principal normal stresses are calculated in the ideal conditions and polar coordinates, which are the effect of a bending a sheet metal in the process of the deep drawing of rotation caps with a bottom. In this way, the directly calculation of the additional stress because of the bending and the correction of a sheet across a radius of a die for drawing is enabled in
mentioned process, which increased stresses in a wall of the cap and a force of drawing.
This is an open access article distributed under the Creative Commons Attribution License which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
The statements, opinions and data contained in the journal are solely those of the individual authors and contributors and not of the publisher and the editor(s). We stay neutral with regard to jurisdictional claims in published maps and institutional affiliations.